Configurare FineOffset WH2900
Configurare l'app WSVIEW
Dopo aver connesso la stazione meteo ad Internet tramite l'app, premere sulla stazione meteo in elenco nella pagina "My Devices", nella sezione "Upload" scorrere fino a Customized ed inserire i parametri come segue:
• Customized: Enable
• Protocol Type: Ecowitt
• Server IP: L'indirizzo IP del computer con installato Weewx (meglio se preventivamente impostato come statico)
• Path: /
• Port: 8000
• Upload Interval: 16 secondi
• Customized: Enable
• Protocol Type: Ecowitt
• Server IP: L'indirizzo IP del computer con installato Weewx (meglio se preventivamente impostato come statico)
• Path: /
• Port: 8000
• Upload Interval: 16 secondi
Installare il driver
• Scaricare il driver Interceptor:
• Installarlo:
• Riconfigurare Weewx:
wget -O weewx-interceptor.zip https://github.com/matthewwall/weewx-interceptor/archive/master.zip
• Installarlo:
sudo wee_extension --install weewx-interceptor.zip
• Riconfigurare Weewx:
sudo wee_config --reconfigure --driver=user.interceptor --no-prompt
Configurazione Weewx
• Aprire il file weewx.conf:
• Sostituire la sezione [Interceptor] con la seguente:
• Modificare la sezione [StdArchive] come segue:
sudo nano weewx.conf
• Sostituire la sezione [Interceptor] con la seguente:
[Interceptor] # This section is for the network traffic interceptor driver. # The driver to use: driver = user.interceptor # Specify the hardware device to capture. Options include: # acurite-bridge - acurite internet bridge, smarthub, or access # observer - fine offset WH2600/HP1000/HP1003, ambient WS2902 # lw30x - oregon scientific LW301/LW302 # lacrosse-bridge - lacrosse GW1000U/C84612 internet bridge # ecowitt-client - any hardware that uses the ecowitt protocol # wu-client - any hardware that uses the weather underground protocol device_type = ecowitt-client port = 8000 iface = XXX [[sensor_map_extensions]] inTemp = temperature_in inHumidity = humidity_in pressure = pressure outTemp = temperature_out outHumidity = humidity_out windDir = wind_dir windSpeed = wind_speed windGust = wind_gust rainRate = rain_rate rain = rain radiation = solar_radiation UV = uv battery = wh65_battery # OPZIONALE: Se volete tracciare lo stato della batteria dei sensori esterniDove in "iface = XXX" al posto delle XXX va inserita l'interfaccia di rete (ad esempio lan0 se il computer è connesso alla rete locale tramite la porta LAN).
• Modificare la sezione [StdArchive] come segue:
# This section is for configuring the archive service. [StdArchive] # If the station hardware supports data logging then the archive interval # will be downloaded from the station. Otherwise, specify it (in seconds). archive_interval = 16 archive_delay = 1 # If possible, new archive records are downloaded from the station # hardware. If the hardware does not support this, then new archive # records will be generated in software. # Set the following to "software" to force software record generation. record_generation = software # Whether to include LOOP data in hi/low statistics loop_hilo = True # The data binding used to save archive records data_binding = wx_bindingIn questo modo Weewx scaricherà i record ogni circa 16 secondi, in modo da non farvi perdere nessun dato!
Avviare Weewx
sudo systemctl start weewxOppure:
sudo /etc/init.d/weewx start